Hood

These measurements are taken with the hood laying flat on the table and do not account for stretch. Typical stretch for standard weight hoods is about 8% and is much less for heavyweight hoods.

Forehead: 19" / 49 cm
Head circumference (under chin, over top of head and back to under chin): 26" / 66 CM
Neck: 14 1/2" / 37 cm
Top of head to bottom of neck (over side of head): 16" / 41 cm

These measurements are taken with the hood laying flat on the table and do not account for stretch. Typical stretch for standard weight hoods is about 8% and is much less for heavyweight hoods.

Forehead: 21" / 53.5 cm
Head circumference (under chin, over top of head and back to under chin): 28" / 70 cmm
Neck: 16" / 40 cm
Top of head to bottom of neck (over side of head): 16 1/2" / 42 cm

These measurements are taken with the hood laying flat on the table and do not account for stretch. Typical stretch for standard weight hoods is about 8% and is much less for heavyweight hoods.

Forehead: 22" (56 cm)
Head circumference (under chin, over top of head and back to under chin): 29" / 73 cm
Neck: 17" / 43 cm
Top of head to bottom of neck (over side of head): 17 1/2" / 44.5 cm

Standard weight thickness is approximately 0.030 inches (0.6mm-0.7 mm).

These products are manufactured by the dipping process so there may be some variation in the measured thickness between different areas of the garments. The thicknesses offered as options are approximate in nature and may not always be exact. In most cases, we'll try to get an average thickness that reflects the desired weight. There should not be a great deal of variation between the thickest portion compared to the thinnest portion but some variation will naturally occur.

Heavyweight thickness is approximately 0.040 inches (0.8mm-1.0mm),

These products are manufactured by the dipping process so there may be some variation in the measured thickness between different areas of the garments. The thicknesses offered as options are approximate in nature and may not always be exact. In most cases, we'll try to get an average thickness that reflects the desired weight. There should not be a great deal of variation between the thickest portion compared to the thinnest portion but some variation will naturally occur.
 

Standard-size facial opening

No facial opening in the hood. Please note that for safety and liability issues, there will be nose holes only to allow breathing if ordered with this option.

This hood has been chlorinated and polished with silicone. The thumbnail version has not been treated other than chlorination.